DAI-3 | PC-plug in cards
| PC-AHV's
prev page | next page |
The optionally available interfaces which are integrated to
amplifiers are described in the corresponding data sheet for the amplifier e.g. LE
150/025-S.
This basic range of interfaces is completed by the units described in the following
section. |
|
1. Stand alone D/A converter DAI-3:
The DAI-3 unit corresponds to the interface option D/A-LE of the LE 150/200 amplifier
system. It shows both serial and parallel (CENTRONIX) data input for handling up to 3
channels independently. The analog output is 0 V thru +10 V and can be plugged directly to
the analog amplifiers described in this on-line catalog. It is obvious, that the DAI-3
unit can be used to control any other system, requiring an analog input control signal. |
| Interfaces: |
serial RS 232
parallel (CENTRONIX) |
Resolution: 12 bit
Output signal: 0 V thru +10 V (other settings e.g. bipolar: on request)
High modulation rate of output: up to kHz with parallel data transfer e.g. for fast
feedback control systems.
Line operation
3 analog independent outputs
|
 |
 |
DAI-3 | PC-plug in cards
| PC-AHV's |
2. PC-plug in cards with analog HV-output
The PC plug in cards generate the analog HV-signal for immediate operation of
Piezoelectric actuators of other loads. The advantages of the PC-AHV cards are the
spacesaving arrangement within the computer cabinet, where no external additional
amplifiers are needed and the speed and reliability of data handling. The cards show
current boosters for elevated driving dynamics.
They are available in single and triple channel versions.General data
- PCI-Bus
- 8 bit data bus
- Setting of port address by DIL switch
- Voltage resolution 14 bit for unipolar output
- 13 bit for bipolar output
- Width 1 slot
- PC board dimensions
|
|
DAI-3 | PC-plug in cards
| PC-AHV's |
PC-AHV +150/1 single channel
Output voltage: 0 V thru +150 V
Max. peak current: 75 mA
Max. average current: 25 mA
Resolution: 14 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |
PC-AHV 150bp/3 triple channel
Bipolar output voltage: -150 V thru +150 V
Max. peak current: 50 mA/channel
Max. average current: 15 mA (total for 3 channels)
Resolution: 13 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |
PC-AHV +150/3 triple channel
Bipolar output voltage: 0 V thru +150 V
Max. peak current: 75 mA/channel
Max. average current: 25 mA (total for 3 channels)
Resolution: 14 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |
PC-AHV +500/1 single channel
Output voltage: 0 V thru +500 V
Max. peak current: 15 mA
Max. average current: 5 mA
Resolution: 14 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |
PC-AHV 150bp/1 single channel
Output voltage: -150 V thru +150 V
Max. peak current: 50 mA
Max. average current: 15 mA
Resolution: 13 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |
PC-AHV +500/3 triple channel
Bipolar output voltage: 0 V thru +500 V
Max. peak current: 15 mA/channel
Max. average current: 5 mA (total for 3 channels)
Resolution: 14 bit
Noise: approx. 50 mV
Output connector: LEMOSA 00.0250 (BNC adapters available) |